HAM 4 CDE Rotor Antenna Rotator + Hygain Control Controller Nice ! - $375.00. AUCTION here is a HAM 4 ROTOR AND NICE HAM 4 CONTROLLER , 8 wire antenna rotor with the control,the rotor has been cleaned inside and out and has some new hardware and new bearings , has a true wedge brake ,painted with a high grade of paint . both the rotor and the controller tested and calibrated works as should ... The healing center online order
As a reference, this voltage “V” in a HAM-IV rotator is 12V, in the Kenpro KR-600RC or YAESU G-2000 is -3.6V, some models use 5V, etc. It is very important to know the voltage “V” provided by your rotator in order to properly set JMP1 (or JMP2 in case of elevation rotator), as well as to adjust the potentiometer P1 (or P2 or elevation).
I have a basic hygain rotor control box... the brake seems to work... but nothing happens when I hit either of the direction buttons, not so much as a blip I have it hooked to a ham 4 rotor both on the bench... I have tried to rotors... Remember the G-5500 is an analog device that is not what anyone would describe as accurate. Yaesu claims "+ or - 4 percent" in their rotor manual. At 360 degrees 4 percent is 14.4 degrees. Even though it is not very accurate the G-5500 is way more than accurate enough for ham radio satellite use.
Vscode switch from terminal to editorMicrosquirt vr sensorThe G-5500 rotor system has variable resistors connected to the azimuth and elevation rotors that are turned along with the antenna. These resistors produce a variable voltage within the rotor control box from 0 volts at 0o to a user set maximum, in this case 4.5 volts at either 450o for azimuth or 180o for elevation. The control CDR HAM ROTOR (antenna rotators) MODEL HAM-M Series 1, 2, 3, 4, 5 precursor to HAM-IV CLASS 252-50 OWNERS MANUAL REPAIR PARTS MANUAL SCHEMATICS 50137-00 ISSUE G ... Mates with original connectors for Hy-Gain HAM IV and similar rotators. Please note, these connectors do not have latching tabs. Please consult the manual for your equipment very carefully when wiring the connector. The pin numbers may not be the same as the original. These connectors are no longer manufactured. This may be our last stock.
CDE HAM Il ROTOR SYSTEM Owner's Manual THE HAM 11 IS RATED FOR ANTENNAS WITH UP TO 7.5 SQUARE FEET OF WIND SURFACE AREA. CORNELL-DUB 1 LIER DIVISION OF FEDERAL PACIFI Rotor Department ELECTRONICS C E L ECT R C C 0M p ANY Fuquay-Varina, North Carolina 27526